Ubuntu hardy and Jaunty not work with B800P

hello
please send your ssh to me:[email protected]
and give me your isdn line number.

Hello,
Please check your dial plan settings first, make sure of them are correct. Moreover, please refer this link, it's the manual of OpenVoxB800P,you can get the LEDs status from it. http://downloads.openvox.cn/pub/manuals/eng/B800P_User_Manual_mISDN.pdf.
Any question please contact me! Or send your SSH and isdn line number to: This email address is being protected from spambots. You need JavaScript enabled to view it. .I will help you as soon as possible!

Best Regards!
Joe.Yung

hello:
please make sure the ports are up, run command: misdn show stacks, you will see the result. if down, you would not make calls. you also need to check the physical connection, make sure the cable is well connected.
regards!
James.zhu

Dear Joe.Yung,

the dialplan is well! This is not the f$&!#&$ problem.
I am also build in the dialplan the dialplan application misdn_check_l2l1.
But it didn't helbed.

I verify the connection and the dialplan and the kernel module with a avm-pci-card and a isdn card with chipset from the hfcpci.
This card worked fine, with this line.


Dear James,

the command misdn show stacks, was very funny.
If i am restarted asterisk, the command results following, and the port witch are connected are lihgting:

Port 1 Type TE Prot. PTMP L2Link DOWN L1Link:UP Blocked:0 Debug:0

after 2 secounds the command results following and the led are blinking:

Port 1 Type TE Prot. PTMP L2Link DOWN L1Link:DOWN Blocked:0 Debug:0

if i am do a call in the two secounds after restart, the result was written before.

best regards

Patrick

the module from misdn v2 for all this listed kernel are not working with lcr.
I think i tested all possible situation with this asterisk channel driver and this kernel module.

the result was:
the lcr stack says the card is ready, but nothing on the card is blinking.
if start asterisk also nothing blinking.

regards Patrick

Can you test this situation with ubuntu hardy and verfify this with asterisk 1.6.0.19?

If you had a working system, please let me know.
Please write down the hooks, or send me this per Email.

If you need my misdn modules in Version 1.1.9.2, please let me know this.

regards Patrick